Olympus E-20N - Manual (Page 194)

192
Problem Solution Page
White mark on the power switch at the ON
position? Move the power switch toward you and
position it at the ON position.
If the camera remains in the sleep mode for
over 1 hour, it will power off automatically. Move
the power switch to the OFF position and then
move it back to the ON position to switch the
camera on. Has the camera been left idle for over 1 hour
with the power on?
Using the camera at low temperature could
temporarily diminish the capacity of the
batteries. Warm some new batteries in your
pocket and insert them in the camera. Have you been using the camera in cold
weather?
Have the batteries been inserted correctly? Remove the batteries and make sure that their
polarities have not been reversed. Re-insert
the batteries correctly.
Are the batteries dead? Insert fresh batteries. If you are using the
lithium polymer battery or Ni-MH battery,
recharge it.
Cannot operate the camera, monitor and control panel blank.
➞ 28
➞ 136
➞ 16
➞ 16
Operational problems
Appendix 2: Troubleshooting