Toshiba Dynadock W20 - Manual (Page 25)

User’s Manual EN-25
dynadock™ W20
7. After successfully completing the association, remove the USB cable
connecting the computer to the dynadock™.
After a few moments, a wireless connection is established and a
message displays in the System tray/Notification Area indicating the
dynadock™ is ready to use.
8. The dynadock™ drivers automatically install. Restart your computer
when prompted.
Connecting your peripherals
Once you have set up a wireless connection between your computer and
the dynadock™, you can connect your computer peripherals to the
appropriate ports on the dynadock™.
Please refer to the “Quick Tour” on page 11 for information on the
dynadock's ports, and refer to the sections below for information on
connecting specific types of devices.
Connecting a monitor
You can connect a digital (DVI) or analog (VGA) monitor to the dynadock™.
Only one monitor can be connected to the dynadock™ at a time.
To connect a monitor to the dynadock™:
1. If you are connecting a VGA monitor, attach the DVI-I to VGA adaptor
(included with the dynadock™) to the DVI-I video port on the
dynadock™.
2. Connect the monitor cable (not provided) to the DVI-I video port on the
dynadock™ or to the adaptor you connected in step 1.
3. Connect the other end of the cable to the external monitor.
For optimal performance, the dynadock™ must be within close range of
the adaptor, with no obstructions between the devices.
NOTE
Restarting may take longer than usual if the computer's operating system
is configured to create a system restore point after a new device is
installed. This occurs after initial installation only. When the computer
restarts, the dynadock™ is ready to use.
NOTE
The monitor cable can be connected/disconnected at any time without
disconnecting the dynadock™ from your computer.
NOTE