Sharp R-1900M User Manual

Page 14

Advertising
background image

13

Procedure

Display

2 Enter memory number.

(After entering the memory
number, the memory setting
of each content is shown for
1.5 seconds at 0.3 second
intervals until the STOP/
CLEAR pad is pressed.)

3 Press the STOP/CLEAR pad to

exit from the Custom Setting
Function.

NOTES:

1. If

CHECK

is displayed at step 2 the memory has not been

programmed.

2. Multiple memories can be checked until the STOP/

CLEAR pad is pressed to exit from the Custom Setting
Function.

3. The way to enter memory numbers depends on the

programmed Memory Input Method.

4. When Express Defrost is set for 30 minutes in the memory,

and

are displayed repeatedly at step 2.

7. Counter Check/Clear
Confi rm counters are set to "0" before using oven for the
fi rst time.

Counter Check
Counter check can be used to check the total number of
times the oven has been used, or the number of times each
pre-programmed memory pad, manual cooking, or Express
Defrost has been used.

Total usage

Press the CUSTOM SETTING pad twice
within 2 seconds, then enter 7. Total usage
will be displayed.

To check more than one counter
Press each pad as indicated below, after the previous usage
is displayed.

Total each

Input memory number.

memory usage

Total manual

Press the MANUAL/REPEAT

cooking usage

pad.

Total Express

Press the EXPRESS

Defrost usage DEFROST

pad.

* Suppose you want to know total usage and each memory

usage. In this case the oven was used 8268 times and
memory 1 in any Memory Input Method was used 513
times.

Procedure

Display

1 Press the CUSTOM

SETTING pad twice within 2
seconds, then enter 7. Total
usage will be displayed.

x 2

2 Enter memory

number 1, to check
the total memory
usage of memory 1.

7

0

1

NOTES:
1. To exit from Counter Check, press the STOP/CLEAR pad.
2. Each counter will count up to 9999, and then will

automatically reset to 0 and begin counting again.

3. As shown in the above example, multiple counters can

be checked before pressing the STOP/CLEAR pad to
exit.

4. Only Dual Digit Input Method can be used when inputting

memory numbers in Counter Check/Clear.

0

1

After about 1 sec.

CHECK

CHECK

CHECK

CHECK

CHECK

CHECK

CHECK

NO.

CHECK

NO.

NO. CHECK

NO. CHECK

After about 1 sec.

CHECK

CHECK

After about 1 sec.

R-1900M [EN].indd Sec1:13

R-1900M [EN].indd Sec1:13

7/4/09 9:50:02 AM

7/4/09 9:50:02 AM

Advertising