X 2 x2/x3 x 2 – Sharp R-1900M User Manual

Page 16

Advertising
background image

15

Air Filter Cycle
Air Filter Cycle can be changed from the factory setting of
100 hours to 001-999 hours

* Suppose you want to set the cycle to 250 hours.

2 Press the MANUAL/REPEAT pad.

3 Enter desired time.

(Ex : Enter 2, 5, 0 for 250 hours).

After about 1 sec.

CHECK

4 Press the START pad to save settings.

Procedure

Display

5 Press the STOP/CLEAR pad to exit from the

Custom Setting Function.

9. Selecting Operation in case of Magnetron Failure
Your oven has 2 magnetrons. In case of single magnetron
failure, the oven can be used until servicing by changing
settings to allow operation under single magnetron only.
However, check food carefully as additional cooking time will
be needed when operating with a single magnetron.

CU91 : Your oven does not work when one magnetron

fails = Factory setting

CU92 : Your oven works even if one magnetron fails.

To set magnetron failure options
Press the CUSTOM SETTING pad twice within 2 seconds then
enter the numbers

9, 1 to stop operation when one magnetron fails
9, 2 to allow operation of one magnetron only

Press the START pad to save settings and the STOP/CLEAR
pad to exit from the Custom Setting Function.

10. Multiplication Factor for Double/Triple Quantity
The multiplication factors of the double and triple quantities
for memory cooking are preset to 1.80 and 2.60. You can
check or change the multiplication factors.

* Suppose you want to know the multiplication factor for

double quantity with memory 1, and change it to 2.00 in
any Memory Input Method.

2

5

0

1 Press the CUSTOM SETTING

pad twice within 2 seconds
and enter 8, 2.

0

1

CHECK

After about 1 sec.

CHECK

NO.

CHECK

NO.

CHECK

NO.

CHECK

NO.

Procedure

Display

1 Press the CUSTOM SETTING

pad twice within 2 seconds
and press the DOUBLE/TRIPLE
QUANTITY pad.

2 Enter memory number.

3 Press the MANUAL/REPEAT pad.

4 Enter desired multiplication.

(Ex : Enter 2, 0, 0 for 2.00.)

5 Press the START pad to save settings.

6 Press the STOP/CLEAR pad to exit

from the Custom Setting Function.

2

0

0

x 2

x2/x3

x 2

8 2

R-1900M [EN].indd Sec1:15

R-1900M [EN].indd Sec1:15

7/4/09 9:50:02 AM

7/4/09 9:50:02 AM

Advertising