Barco R9001490 - Manual (Page 16)

3-2
Installation Guidelines
5976072 BARCO ELM R12 17102000
Regardless of the type of screen used, it is important that your screen is of sufficient height to display the images at the aspect ratio
intended to be used. If you have insufficient height, you will have to reduce the overall image size in order to display the full image
on your screen.
For more information about screens, contact your local screen supplier.
What image size? How big should the image be?
The projector is designed for projecting an image size : min 1.00m (3.3ft) to max depending on the ambient light conditions, with a
aspect ratio of 5 to 4.
Projector Configurations
Which configuration can be used.
The projector can be installed to project images in four different configurations :
front/table,
rear/table,
front/ceiling or
rear/ceiling.
Positioning the Projector
The projector should be installed perpendicular with the screen on a distance PD and water leveled in both directions.
Four mounting positions are possible.
Be aware for the weight of the projector : 143.5 kg without projection lens.
To carry the projector by the carry handler, 4 persons are needed.
To carry the projector with a fork lift, special fork lift tools are available (see carry options).
The mounting position shown in the above images are shown for a nominal lens position.
When putting the projector on the 3 adjustable feet, use these feet to level the projector by turning these feet in or out.
Definitions of the Abbreviation on drawings
B = Distance between ceiling and top of the screen or between floor and bottom of the screen.
A = 344 mm , distance from the middle of the lens (in nominal position) to bottom side of the projector. A shift of ± 20 mm up down
is possible.
CD = Total distance between projector and ceiling or projector and floor.
SW = Screen width.
SH = Screen height (image height).
PD = Projector Distance, distance between screen and projector.
Front/Table
Front/Ceiling
Rear/Table
Rear/Ceiling
Image 1