Brocade Communications Systems Brocade VDX 8770-4 - Manual (Page 38)

18 Brocade VDX 8770-4 Hardware Reference Manual
53-1002563-02
Providing power to the Brocade VDX 8770-4
2
Connecting an AC power cord
1. Plug the power cord into the power supply.
2. Route the cable so it will be out of the way when connected to the power source.
3. Plug the other end of the cable into the power source.
Connecting a DC power cord
1. Use a #1 Phillips screwdriver to remove the screw that secures the safety cover over the power
lugs and remove the safety cover.
2. Use a #2 Phillips screwdriver to unscrew the power lugs.
3. Crimp the #2 AWG power supply wires into the power lugs.
4. Connect the power lugs to the power supply unit.
Connect the -48V wire to the negative terminal and the 0V wire to the positive terminal.
NOTE
The DC return must be isolated from the chassis ground (DC-I) when making connections to
the connections to the power supply.
5. Replace the safety cover.
6. Plug the other end of the cable into the power source.
ATTENTION
Do not connect the switch to the network until the IP addresses are configured.
For information about LED patterns, see Chapter 4, “Monitoring System Components” .