Brocade Communications Systems Brocade VDX 8770-4 - Manual (Page 69)

Brocade VDX 8770-4 Hardware Reference Manual 49
53-1002563-02
Line card removal and replacement
5
FIGURE 11 Removal and replacement of the vertical cable management finger assemblies
Replacing a cable management finger assembly
Complete the following steps to replace the cable management finger assembly.
1. Position and tighten the three screws to secure the vertical cable management finger
assembly to the rack upright.
2. Arrange the cables along the cable management finger assembly.
3. If necessary, repeat step 1 and step 2 for the other cable management finger assembly.
Line card removal and replacement
This section describes how to remove and replace line cards. It does not cover the management
modules or the switch fabric modules. It covers the removal and replacement of line cards of the
same type. If you need to replace a line card with a line card of a different type, please consult the
Brocade Network OS Administrator’s Guide.
ATTENTION
Any slot that is not occupied by a line card should be occupied by a filler panel to ensure correct
cooling of the chassis and protection from dust.
Line card slots are numbered from L1 through L4, from top to bottom when facing the port side of
the Brocade VDX 8770-4.