Belkin OmniViewIP 5000HQ - Manual (Page 38)

34
OmniView IP 5000 HQ
sections
table of contents 1 3 5 7 9 11 13 15 17 19 2 4 6 8 10 12 14 16 18 20 21 15
ManaGeMenT
Next, configure the PDU’s power outlets according to the physical
connection to the server or other equipment by clicking on
the tab.
Drag the target name from the right side’s current targets list to the left
side’s corresponding power outlet. Double-click on the target name on the
right side to remove the selection. Repeat for each power outlet, and click
when you’re done. Your PDU has been configured and the
power option ( ) becomes available from the “Access” tab.
Figure 46 Adding new PDUs – Outlets tab
Figure 47 Performing power commands
The following commands can be performed from the HQ interface.
Figure 48 Power commands
To cancel, click .