1 default access service – Belkin OmniViewIP 5000HQ User Manual
Page 71
67
OmniView IP 5000 HQ
COnfIGUrInG aCCess serVICes fOr InDIVIDUal TarGeTs
sections
1
3
5
7
9
11
13
15
17
19
2
4
6
8
10
12
14
16
18
20
21
As explained in the “Configuring Access Services” section, the Access
Service default values are set globally in the “Settings” section of the
menu, in “Applications/Access Services”. The following sections explain
how to configure each Access Service for individual targets.
You configure the Access Services for each target from the
“Access Services” tab, as follows:
1. From the “Management” menu, select “Targets” and the “Targets”
page appears; see Figure 80.
Figure 80 Targets page
2. For new targets, click the “New Target” button; for existing Targets,
click the target name in the name column. The “Access Services”
tab appears.
12 .1 Default access service
You can set any of the Access Services to be the default service. This
means that the service will be used to access the target by default when
selecting the target name. To access the target via a different service,
the service must be selected. To set a service as the default, display
the service as explained below and select the “Set as Default Service”
check box.