Belkin OmniViewIP 5000HQ - Manual (Page 9)

5
OmniView IP 5000 HQ
sections
table of contents 1 3 5 7 9 11 13 15 17 19 2 4 6 8 10 12 14 16 18 20 21
UnDersTanDInG THe sysTeM – an OVerVIeW
5
The figure below shows a typical OmniView IP 5000HQ application. 3 .1 Creating users
An administrator can create users with two different possible permission
types:
• Administrator
• User
A user can be a full user or just view only. These permission types are
explained fully in the “Account policy” section. In the example below,
four users are created with various permission types.
The system works as follows:
Data centers in locations throughout the world are connected to Belkin
IP devices and to other third-party Access Services. The Belkin IP
devices are HQ-enabled, allowing the OmniView IP 5000HQ to access/
control the targets connected to all IP devices via IP.
Users access the OmniView IP 5000HQ web interface and, depending
on their level of access permissions, can access and control the targets.
Figure 3 OmniView IP 5000HQ typical application
Once an administrator creates targets or sets of targets (explained
below) in the system, users can be assigned access to individual targets
or sets of targets.
Figure 4 Users with different permissions