Philips 50PF9830A-37B - Manual (Page 61)

57
English
& Connect an S-Video cable to the AV1 or AV2 S-
VIDEO input 1.
Note: When using the S-VIDEO connector do not
connect any device to the AV VIDEO input that you
are using.
é Connect the audio cables to the device’s AUDIO
L and R jacks and to the L and R audio AV1 or
AV2 jacks 2 on the TV accordingly to where
you connected the S-Video cable.
Devices with an S-Video connector
Notes
- If necessary, you can adjust the picture position to the center of the screen with the cursor keys.
- The labels for the component video sockets may differ depending on the DVD player or the device connected.
Although the abbreviations may vary, the letters B and R stand for the blue and red component signals,
respectively, and Y indicates the luminance signal. Refer to the DVD player’s or devices instructions for use for
definitions and connection details.
- This television is designed to accept high definition signal standards 480p, 720p and 1080i as specified by the
Electronic Industries Association standard EIA770.3.
Digital devices from different manufacturers have the possibility of differing output standards which may cause
difficulties for the television to properly display.
- Due to possible digital image distortion when displaying signals from connected digital equipment, automatically
the Auto picture setting Soft is selected, if you selected Digital STB in the Source menu. See Picture menu, Auto
picture, p. 26.
Changing this setting during reviewing will not be stored as
Personal setting after switch off.
Warning : in case you notice scrolling images, wrong colors or no color, no picture, or even combinations of these
on your screen, check if the connections are done in the correct way or move your digital device further away
from your TV.
L Pr H
R Pb V
DIGITAL
AUDIO
IN Y
Pr
Pb
Y
S-VIDEO
S-VIDEO
AV2
AV3
AV1
VIDEO
L
R
VIDEO
AV1
AV2
DVD / STB
AV1/AV2 :
S-VIDEO
1
2
AV1/AV2 :
L + R
2496.1 16x24 en 14-12-2005 10:11 Pagina 57