Philips 50PF9830A-37B - Manual (Page 71)

67
English
( Press for about 2 seconds on the remote control of your external device the function button you
want to be learned by your TV remote control.
The LED of the selected source on your TV remote control is blanked during the capture of the
signal.
When the function is copied, the LED is lit again.
§ Repeat steps “ to ( again to copy other functions.
è To exit the learnable mode:
Press the button at the side of your TV remote control for about 2 seconds.
Your remote control will remain the last selected mode.
Note: If a code from the remote control of your external device is not recognized by the TV remote control, the
LED of the selected source will blink for a few seconds. This means that the code transfer did not succeed.
To put the remote control function buttons back to the factory mode
& Press the SELECT button repeatedly to select TV mode.
é Press the OK button and the MUTE button simultaneously for at least 5 seconds.
All the SELECT LEDS will light up.
“ Press the SELECT button
• 1x: DVD/R is lit up
• 2x: CBL is lit up
• 3x: VCR is lit up
• 4x: AUX is lit up
• 5x: DVD/R , CBL , VCR , AUX are lit up.
‘ Press the OK button when one or all mode LEDS are lit.
The function buttons which were ‘learned’ will be erased or from the selected destination source or
from all the external devices at once.
All the buttons from the TV remote control will have their factory function again.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio or television technician for help.
Modifications -
The FCC requires the user to be notified that any changes or modifications made to this device that are not
expressly approved by Philips Consumer Electronics may void the user’s authority to operate the equipment.
Cables -
Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain
compliance with FCC Rules and Regulations.
Canadian notice -
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Avis Canadien -
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du
Canada.
Regulatory Notices - Federal Communications Commission Notice
2496.1 16x24 en 14-12-2005 10:11 Pagina 67