Getting started, Installation – Fluid Management 1500HS Accutinter User Manual
Page 15
Fluid Management Customer Service 1 . 800 . 462 . 2466
Accutinter 1500 | 13
6
Plug in the power cord and connect all cables.
a. Route the keyboard, monitor, and mouse cables to the rear of the machine where the computer has been
placed. Plug them into the appropriate ports on the back of the computer.
b. If you purchased the optional barcode scanner, label printer or are using a spectrophotometer, route the
cables to the rear of the machine where the computer has been placed. Plug these cables into the
appropriate ports on the back of the computer.
c. Connect the USB cable coming out of the hole of machine where the
computer has been placed. Attach the USB cable to the port labeled
“
DISPENSER” on the back of the computer. See Figure 2
d. Plug the power cords from the monitor, computer and Accutinter into
the recommended surge protector.
e. Plug the surge protector into a 15 amp dedicated electrical outlet.
7
Turn on machine.
a. Locate the front panel below the nozzle closer in the center of the
machine.
b. Locate and unscrew the two Phillips head machine screws provided.
c. Open the front panel and locate on the red toggle switch near the
bottom of the compartment.
d. The red toggle switch needs to be in the ‘ON’ position on or ‘RESET’
position for the Accutinter to work properly.
e. Close the front panel and screw in the two Phillips head machine
screws provided.
8
Turn on computer and monitor.
Locate the on/off button on your computer and turn it on. Reference the computer’s user manual if you have
difficulty locating.
9
Locate the ColorPro icon on your desktop.
ColorPro and your manufacturer’s database were loaded at Fluid Management’s factory. If you cannot locate
the ColorPro icon, load software using the backup CD provided. Open ColorPro by double clicking on the icon.
10
After the machine is installed, fill the canisters and update ColorPro
Complete an initial manual dispense for each colorant.
(See “Getting Started: Preparing and refilling the canisters” on page 16).
FIGURE 2
Getting Started
Installation