Fluid Management 1500HS Accutinter - Manual (Page 8)

Fluid Management Customer Service 1 . 800 . 462 . 2466

6 | Accutinter 1500
Important Safety Information
WARNING:
Unplug before
servicing
WARNING:
DO NOT use with or
near flammables
Use a dedicated
15 amp circuit
Information and Instruction Labels
You should become familiar with the information labels affixed to the machine,
as well as the warnings, cautions, and notes which appear throughout this guide.
Read all the warning labels on the exterior and interior of the dispenser. If the
labels become damaged or unreadable, you may purchase replacements from
Fluid Management Customer Service.
Safety Notice Information
The two main notices used in this Guide and on the
Accutinter 1500 / Accutinter 1500 HS are Warning and
Caution. A Warning notice tells you about a hazard that
could cause serious injury to you or extensive damage to
the equipment. This information is featured in the beginning
of the guide to emphasize safety.
When you see a Warning notice in this guide, read it carefully before continuing with the
operation of the machine. Take all necessary precautions to avoid potential injury.
A Caution notice tells you about a danger that could cause
injury to you or minor damage to the dispenser. When you
see a Caution notice in this guide, read it carefully and be
sure you understand it before continuing.
General Safety Information
DO NOT attempt to service a product yourself unless instructed to do so by Fluid
Management Customer Service. Use only a Fluid Management Authorized Service
Technician to repair your equipment. Please note that some parts can be upgraded or
replaced by the customer. Fluid Management identifies those parts as such and provides
documentation with instructions when it is appropriate for customers to replace those
parts. You must closely follow all instructions when performing such replacements.
ALWAYS make sure that the power is turned off and that the machine is unplugged
before you attempt the replacement. If you have any questions or concerns, contact
Fluid Management Customer Service.
Air Circulation
Your computer and monitor for your dispenser produce heat. The computer has a fan
that pulls in fresh air and forces out hot air. The monitor lets hot air escape through
vents. Blocking the air vents can cause overheating, which might result in a malfunction
or damage. Place the computer and monitor so that nothing blocks the air vents. Allow 4
inches (101.6 mm) clearance around air vents.
•
WARNING
HAZARDOUS
ELECTRICAL
COMPONENTS
•
CAUTION:
POTENTIAL
SAFETY
HAZARD