Fluid Management 1500HS Accutinter - Manual (Page 19)

Fluid Management Customer Service 1 . 800 . 462 . 2466

Accutinter 1500 | 17
Getting Started
Preparing and refilling the canisters
After your machine is installed in the proper location, you need to fill the canisters with colorant so you
can dispense for the first time. Your machine may be shipped with a small amount of glycol or colorant in
the canisters already, but you need to fill them to capacity with colorant. When re-filling canisters, you will
follow the same process using steps 3-8. Canisters come in varying capacities. Check the label inside
the top cover for capacity and colorant locations.
DO NOT overfill the canisters. After the canisters are
filled, ColorPro (or your manufacturer’s software) must be updated (See page 18).
Cautions
• DO NOT operate the
dispenser until it is in a
permanent location.
• DO NOT dispense if
canisters are empty
• Before dispensing colorant
for the first time, you
must complete a manual
dispense.
• DO NOT dispense without a
container in place.
• DO NOT use shelf surface to
seal open cans.
1
Raise the top cover of the
Accutinter so you can see
the canisters inside.
2
Remove the caps from
each canister one at a
time and prepare to fill
them with colorant.