ARB 3421520 - Manual (Page 10)

Last Rev Date: 14/10/2010 Page 10 of 22 Fitting instructions# 3787836
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION TO VEHICLE
30. Remove reinforcing beam at mounts to
chassis by undoing the M10 fine thread bolts.
Set beam aside, it will not be reused
31. Remove clamp from power steering pipes, by
undoing the M10 bolt into the side of the
chassis and the bolt holding the clamp plate.
Set aside as this bracket will be reused
32. Repeat for other side of vehicle
33. Using a power drill with Dia13mm bit, drill out
captive nut in hole immediately behind
chassis flange as shown, for both RH and LH
chassis ends
Warning: Cutting operations can result in flying
debris, safety glasses should be worn.