ARB 3421520 - Manual (Page 11)

Last Rev Date: 14/10/2010 Page 11 of 22 Fitting instructions# 3787836
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION TO VEHICLE
34. Starting with RHS of vehicle, insert M12
cage nuts to nut plate extensions
35. Bend up the nut plate on the RHS only as
shown, this is to clear cross tube in chassis.
36. Insert nut plates in chassis holes with
approximately 40mm still protruding
37. Fit handed specific side brace as shown,
locating over the captive nuts at the rear of
the chassis.
38. When the RHS side brace are fitted in
position as shown, insert fine thread M12
x1.25P x 30 bolt and washer sets into
lowest hole position to chassis. There is an
existing captive nut in chassis, but do not
do up tight.
Locate in hole then
bend up as shown