ARB 3421520 - Manual (Page 9)

Last Rev Date: 14/10/2010 Page 9 of 22 Fitting instructions# 3787836
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION TO VEHICLE
.
26. Mark cutting line on each bumper retaining
clip as shown (RHS shown)
27. Cut along marked line with jigsaw or similar
cutting device. Clean up and deburr forward
section then discard rear section
.
28. Once cut, replace forward section only of clip
to vehicle as shown
29. Remove reinforcing beam foam pad, then
remove the beam, refer next step.
Warning: Cutting operations can result in flying
debris, safety glasses should be worn.
Cut edge
Mark cutting
line as shown
then cut
Rear section
discard