ARB 3421520 - Manual (Page 18)

Last Rev Date: 14/10/2010 Page 18 of 22 Fitting instructions# 3787836
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
BULL BAR FITMENT TO VEHICLE
WINCH FITMENT ONLY
75. Fit the two bracing straps from the top face
of the gusset on the mounting bracket to the
bottom of the flange on the rear of the winch
bracket in bull bar
NOTE: The M10 bolts must have the nuts on
the lower side
76. Using a Dia10mm drill bit, drill and pin the
straps at the adjustment end using the pilot
hole as a guide, as shown (note strap fits
above the gusset as shown).
77. Fit and torque the M10 pinning bolts and
flange nut sets to specifications.
Warning: Drilling operations can result in flying
metal debris, safety glasses should be worn.