ARB 3421520 - Manual (Page 6)

Last Rev Date: 14/10/2010 Page 6 of 22 Fitting instructions# 3787836
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION TO VEHICLE
8. Temporarily apply some masking tape joining
the cutting line positions from each of the
bumper outer sections. Apply the tape so the
top edge is on the cutting line
9. Apply 50mm masking tape along the top side
of the cutting line right across the bumper as
shown.
NOTE: The bottom edge is on the cutting line
10. Once bumper cutting has been marked out,
the bumper can be removed
.
11. Remove the plastic rivets securing the
courtesy panel above the grille
Marked
cutting line
Marked
line from
template