ARB 3421520 - Manual (Page 16)

Last Rev Date: 14/10/2010 Page 16 of 22 Fitting instructions# 3787836
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
WINCH FITMENT ONLY
62. Insert the two rubber grommets into the top
face of bull bar.
63. Attach the control box to the control box
bracket as shown.
64. Fit the control box to the bull bar with two M8
x 25mm bolts, M8 flat washers and M8 flange
nuts.
65. Run the cables through the rubber grommets
and connect to the winch as per the wiring
diagram supplied with the winch.
66. Using cable ties fix the cables securely and
ensure they are well away from any moving,
sharp or hot surfaces.