ARB 3421520 - Manual (Page 12)

Last Rev Date: 14/10/2010 Page 12 of 22 Fitting instructions# 3787836
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION TO VEHICLE
39. Insert M12 flange nut through hole in
chasses flange, you can retain with ring
spanner, then insert M12 x 35 coarse pitch
bolt and washer set, but do not do up tight
40. Insert M12 x 35 coarse pitch bolt and washer
set into rearmost hole into cage nut on
extension plate, but do not do up tight
NON KDSS EQUIPPED VEHICLES
41. Proceed to fit LHS brace as per RHS
instructions in previous steps
KDSS EQUIPPED VEHICLES
42. If the vehicle has KDSS, using a power drill
with Dia19mm (3/4´ ELW or holesaw, drill out
rear brace mounting hole in chassis face
outboard side only as shown
43. Fit the LHS brace into position as per the
RHS instructions with the following
exception.......
44. The cage nut on extension plate is not fed
through the front end of the chassis and
used for the rear bolt position, instead fit
the supplied M12 x 100 bolt and flat
washer to the rearmost hole in the brace,
then fit the two sleeves over the bolt. Fit
the brace while fitting the bolt and sleeve
combination into the opened up hole, fit the
M12 flange nut to the bolt on the inside of the
chassis but do not do up tight.
45. Fit the other bolts as per RHS, snugged
up but do not do up tight
Warning: Cutting operations can result in flying
debris, safety glasses should be worn.
Rear bolt location
Bolt assembly KDSS
equipped vehicles