ARB 3421520 - Manual (Page 8)

Last Rev Date: 14/10/2010 Page 8 of 22 Fitting instructions# 3787836
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
PREPARATION TO VEHICLE
.
18. Carefully, and ideally with the aid of a friend,
unclip each outer of the bumper at the guard
as shown and remove bumper.
19. Place bumper face up on cutting table.
.
20. With the bumper face up and on a suitable
bench or the like, carefully cut the bumper
along the cutting line with a jig saw or similar
tool. Take care not to damage surface
above cutting line.
21. When finished cutting, deburr cut edge with
file, then remove protective tape.
.
22. Remove the plastic bumper retaining clips
from each side of the vehicle
23. Mask up the fenders and headlamps as
shown
24. Spray paint black the area immediately
below the fender edge which will be partially
visible when the bull bar is fitted
25. Remove masking tape and allow paint to dry
Warning: Cutting operations can result in flying
debris, safety glasses should be worn.
Once refitted, cut edge of
bumper should now look like this
VIEW OF CUT BUMPER BACK ON
VEHICLE FOR REFERENCE ONLY