SkyTrak 10054 Operation Manual - Manual (Page 146)

144 Model 10054 Rev 3/02
General Maintenance
5. Pressurize the park brake with the pressurizing unit. Close the
pump needle valve.
6. Working through the level plug hole (Figure 99), carefully use a
screwdriver to spread the brake disks apart.
IMPORTANT! DO NOT damage the surfaces of the brake disks when
spreading the brake disks.
Figure 99
7. Using a feeler gauge, check the gap (Figure 100) between the
brake disks. If the gap is greater than .26" (6,75 mm), replace the
brake disks.
NOTE: If the brake disks are worn beyond .26" (6,75 mm), the brake disk
must be replaced on both sides of the axle at the same time.
8. Repeat step 6 and step 7 for the other side of the axle.
9. Continue with step 6 of “B. Axle Oil Change” on page 141.
Level Plug Hole
MT2850
144
Model 10054 Rev 3/02
General Main tenan ce
5.P res surize thepar kbr ake with thepr essur izi nguni t.Cl ose th e
pu mpnee dlev alve.
6.W ork ingthr ough the lev elpl ugh ole( Figu re 99), car efull yus ea
sc re wdr iver tosp read theb ra ke dis ks apart .
IMPOR T ANT! DONO Tdam agethe surf aces of thebr ake disk sw hen
spre adin gt heb ra ke dis ks.
Figure 99
7.Us ing afee lerg auge, chec kt hegap (F igu re 100) between the
bra ke dis ks .I ft he gap is greate rthan .26" (6, 75m m), repl ace the
brak ed isks .
NOTE:If thebr ake dis ksa re worn bey ond.26 "( 6,75 mm) ,th ebr ake dis k
must be re pla ced onb oth side so ft he axle att he sam et im e.
8.Re peat step 6an ds tep7 for the other side of theax le.
9.Co ntinue with step 6of “B .A xle Oil Chang e” onpag e14 1.
Level PlugH ole
MT2850