SkyTrak 10054 Operation Manual - Manual (Page 40)

38 Model 10054 Rev 3/02
Operation
Instrument Cluster Light Test
(Figure 18)
Test the bulbs in the instrument cluster before starting the engine.
Turn the ignition switch to the RUN position, ALL nine lights in the
instrument cluster will come ON for a few seconds and then go out. Replace
any bulbs that DO NOT come ON during this test. These lights will warn the
operator if an abnormal condition should arise during operation and will also
inform the operator when the Stabil-TRAK system is active, road lights are
on high beam or the turn signals are activated.
Figure 18
Refer to Figure 18 for position of corresponding lights:
• Alternator Charging Light (1)
• Park Brake Light (2)
• Engine Oil Pressure Light (3)
• Engine Coolant Temperature Light (4)
• Hydraulic Tank Temperature Light (5)
• Transmission Temperature Light (6)
• High Beam Light (7)
• Stabil-TRAK Light (8)
• Turn Signal Light (9)
0000 00
P
OH1810
(1)
(2) (3)
(4) (5)
(6) (7)
(8) (9)
38
Model 10054 Rev 3/02
Operati on
InstrumentC luster Lig htTest
(F igur e1 8)
T es tt he bul bsin thein stru ment clus ter bef ore star ting theeng ine.
T ur nthe igniti ons witch tot heR UNpos ition ,AL Lni neli ghts in th e
in str um entc lust erwil lc ome ON for af ew seco ndsan dt hen go out. Rep lace
an yb ulbs thatDO NOT com eO Ndur ing thi st est. Thes el ights will wa rn the
oper ator if an abnor malco nditio nsho uld aris edur in go perati ona ndwil lal so
in fo rm th eo perat orwhe nthe Stabi l-T RA Ks ys tem is act ive ,r oadli ghts are
on high beam ort he turn sign als are activ ated.
Figure 18
Refe rt oF igur e1 8f orpo sitio nof corr espo nding lights :
• Alte rnato rChar ging Light (1)
• Pa rk Brak eL ight (2 )
• Engi neO il Pres sur eLi ght( 3)
• Engi neCool ant T emp eratu re Light (4 )
• Hydr auli cT ankT emper atur eLi ght( 5)
• T ran smis sion T emp eratu re Light (6 )
• High Beam Ligh t( 7)
• Stab il-T RA KL ight (8 )
• T ur nSi gnal Ligh t( 9)
0000 00
P
OH181 0
(1)
(2) (3)
(4) (5 )
(6) (7)
(8) (9)