SkyTrak 10054 Operation Manual - Manual (Page 23)

SafetyPr actices
21
Model 10054 Rev 3/02
DONO Tb y-p as so rd isco nnect any ele ctr ic al or hyd raulic cir cuits.
Cons ultthe OmniQ uipS erv ic eD epar tment or your OmniQuip
Au thoriz ed Ser vic eC enter (A SC)i fany cir cui ti sm alfunc tioni ng.
DOch eck for frayed orc ut seat be ltw eb bing ,d amaged bu ck les or loo se
moun ting bra cke ts. Replac ei mmedi ately if re quire d.
ALW A Y Sw eara se atb eltwhe nop erati ngthe veh icle .
DOc he ck tir ep ress ure on all fo urtir es.A ddair if requ ired .
DOc hec kt hec ondit ionof all four rims .C heck for bent flan gesan d/or
bea dm oun tin gar eas .
DOc hec kt hep ark ingbr ake operati on.Ref erto the test proc edure son
page 184. Rep airi mmedi ately if re quire d.
DOk eep all non- sk id sur fac esc lean andfr ee ofde bris. Replac ei fw orn,
dama gedor miss ing.
DOc he ck the co nd ition ofd ecal s. Repla cedec als if mis sin g, da mag ed
or illeg ib le .F igu re 3a ndF igur e4 onthe fo llo wing pages sho wt he
pro perl ocati ono fthe decal s.
Equipme nt Cons ideratio ns
WA RNING:
DON OT modi fyor alter (w eld, dril l,e tc .) an y
part oft his ve hicl ew ith ou tf irst cons ulti ng OmniQuip. Modi fica -
tion sc anw eak ent hes truc ture crea ting ahaz ard that canc ause
death ors erio usper sona li njur y.
Safety Practices
21 Model 10054 Rev 3/02
DO NOT by-pass or disconnect any electrical or hydraulic circuits.
Consult the OmniQuip Service Department or your OmniQuip
Authorized Service Center (ASC) if any circuit is malfunctioning.
DO check for frayed or cut seat belt webbing, damaged buckles or loose
mounting brackets. Replace immediately if required.
ALWAYS wear a seat belt when operating the vehicle.
DO check tire pressure on all four tires. Add air if required.
DO check the condition of all four rims. Check for bent flanges and/or
bead mounting areas.
DO check the parking brake operation. Refer to the test procedures on
page 184. Repair immediately if required.
DO keep all non-skid surfaces clean and free of debris. Replace if worn,
damaged or missing.
DO check the condition of decals. Replace decals if missing, damaged
or illegible. Figure 3 and Figure 4 on the following pages show the
proper location of the decals.
Equipment Considerations
WARNING:
DO NOT modify or alter (weld, drill, etc.) any
part of this vehicle without first consulting OmniQuip. Modifica-
tions can weaken the structure creating a hazard that can cause
death or serious personal injury.