SkyTrak 10054 Operation Manual - Manual (Page 185)

TestProcedures
183
Model 10054 Rev 3/02
Step 4
a. Pu tt he tra ve ls ele ctle ve rin th e( F) FO RW ARD posit ionand the
gear se le ct leve ri nt hefir st gear posi tion.
b. Attem ptto acce lera tethe ve hicle. The vehi cle shou ldn ot mo ve .
c. Ifthe ve hicle attemp tsto mo ve ,ST OPa nd ha ve th es ys te m
re pa ired befo reus ingthe ve hicl eag ain.
Step 5
a. Attem ptto frame sw ay thev ehic le to the rig hta ndle ft,it shoul d
fram es wa yb ut ata slo we rs peed th an nor mal.
b. Th eS tabil- TR AK lig ht shou ldre main ON.
c. Retur nt hev ehic leto ale vel positi on.
Step 6
a. Pla ce the tra ve lse lect le ve rin the( N)NE UTRAL po sit ion, mov e
the neutr al loc kle ver toN EUTRAL LO CK pos ition.
b. Fu lly retr act theboom .
c. Rais et he ou trigger s.
d. Enga gethe par kin gbr ak es witc h,s hutO FF the engi neand
rem ove th ek ey.
e. Ex it the vehi cle usi ngthe hand ho lds.
Ifst eps1 thr ough 5p ro ve posit ive ,the Boom/ Ou trig gerIn terloc kSy stem is
func tionin gp ro perly and the veh ic le ca nbe retur ned to ser vic e. Ifan yof
thes es teps indi cate thatthe Boom/O utrigg erInte rlo ck Sy stem is not
func tionin gp ro perly ,c ontac ty our loc alOmni Quip Auth ori ze dS erv ic e
Center (A SC)i mmedi ately to rep airth es yste m.
Test Procedures
183 Model 10054 Rev 3/02
Step 4
a. Put the travel select lever in the (F) FORWARD position and the
gear select lever in the first gear position.
b. Attempt to accelerate the vehicle. The vehicle should not move.
c. If the vehicle attempts to move, STOP and have the system
repaired before using the vehicle again.
Step 5
a. Attempt to frame sway the vehicle to the right and left, it should
frame sway but at a slower speed than normal.
b. The Stabil-TRAK light should remain ON.
c. Return the vehicle to a level position.
Step 6
a. Place the travel select lever in the (N) NEUTRAL position, move
the neutral lock lever to NEUTRAL LOCK position.
b. Fully retract the boom.
c. Raise the outriggers.
d. Engage the parking brake switch, shut OFF the engine and
remove the key.
e. Exit the vehicle using the hand holds.
If steps 1 through 5 prove positive, the Boom/Outrigger Interlock System is
functioning properly and the vehicle can be returned to service. If any of
these steps indicate that the Boom/Outrigger Interlock System is not
functioning properly, contact your local OmniQuip Authorized Service
Center (ASC) immediately to repair the system.