SkyTrak 8042 Service Manual - Manual (Page 130)

3.69 Model 8042, 10042, 10054 Legacy Rev. 03/04
Boom
23. At the rear of the boom, remove the capscrews (19),
lockwashers (20) and flat washers (21) holding the
hose reel assembly (22), lower wear pad (23) and
spacer (24) to the lower plate on the primary
intermediate boom. Reassemble the capscrews,
lockwashers and flat washers to hold the lower wear
pad in place for primary intermediate boom removal.
24. Remove the capscrews (25), lockwashers (26) and flat
washers (27) holding the hose reel side plate (28),
lower left side wear pad (29) and shims (30) to the side
of the primary intermediate boom. Save the capscrews,
lockwashers, flat washers, shims and wear pad
inserts (31). Watch for the six washers (32) to fall out
from between the side plate of the hose reel
assembly and the side plate of the primary intermediate
boom.
25. Remove the hose reel (33) as an assembly, from the
rear of the boom.
26. Inside the secondary intermediate boom, loosen, but
DO NOT remove the two capscrews (34) securing
the upper left side wear pad and hose clamp support
bracket (35) to the top of the secondary intermediate
boom.
27. Remove the two capscrews (36) and
lockwashers (37) holding the stack clamps (38) and
hose clamp support bracket (35) to the left side of
the secondary intermediate boom. Remove the
clamps and the clamp support bracket from the
secondary intermediate boom.
MH1820
12
13
14 15
16
17
18
MH1030
19
20
21
22
23
24
MH1040
25
26
27
28
29
30
31
32
33
MH2840
35
34
35
36
37
38