SkyTrak 8042 Service Manual - Manual (Page 854)

10.13 Model 8042, 10042, 10054 Legacy Rev. 10/03
Stabil-TRAK™ System and Boom Interlock System
4. Place an Accident Prevention Tag on both the
ignition key switch and steering wheel, stating that
the vehicle should not be operated. (Refer to Section
1.5, “Accident Prevention Tags.”)
5. Unlock and open the rear door. Allow the engine,
transmission and hydraulic fluid to cool.
6. Disconnect the pressure switch wiring connector (1)
from the harness connector (2).
7. Remove the outrigger pressure switch (5) from the
outrigger cylinder.
8. Wipe up any spilled hydraulic oil.
c. Installation
1. Install the pressure switch (5), and torque to 25-38
lb-ft (34-41 Nm).
2. Connect the pressure switch wiring connector (1) to
the harness connector (2).
3. If the vehicle has one battery, connect the
negative (-) battery cable to the negative (-) battery
terminal (3).
If the vehicle has dual batteries, connect both
negative battery cables to both negative (-) battery
terminals (4).
WARNING:
Hot hydraulic fluid can
cause severe burns. Wait for hydraulic fluid to
cool before servicing any hydraulic component.
WARNING:
Escaping hydraulic fluid
under pressure can penetrate the skin, causing
death or serious injury. Relieve hydraulic
pressure before servicing any hydraulic
component.
MH4130
5