SkyTrak 8042 Service Manual - Manual (Page 181)

Boom
3.120 Model 8042, 10042, 10054 Legacy Rev. 03/04
60. Use a hoist and slings to position the Attachment Tilt
cylinder (1) inside the gooseneck (2). Be sure the
Attachment Tilt cylinder is positioned with the tube
for the rod end positioned inside the gooseneck.
61. Coat the base end pivot pin (3), saved, with anti-
seize compound. Line up the hole in the cylinder
base end with the mounting holes in the gooseneck,
and insert the pivot pin through the gooseneck.
Secure the pivot pin to the gooseneck with the two
retaining rings (4), saved. Be sure the retaining rings
are securely seated in the pivot pin grooves.
62. Coat the rod end pivot pin (5), saved, with an anti-
seize compound. Swing the rod end (6) of the
Attachment Tilt cylinder up and line up the rod end
with the mounting holes in the quick attach (7).
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
63. Insert the rod end pivot pin (5) through the lined-up
holes. Use a tapered punch to line up the capscrew
hole in the pivot pin and the mounting hole in the
quick attach hub. Insert the capscrew (8), saved,
through the quick attach hub from the backside and
secure in place with a new elastic locknut (9).
Tighten securely.
64. Connect the Attachment Tilt hoses from the rear of the
gooseneck to the fittings on the base end of the
Attachment Tilt cylinder:
a. Connect the left side hose (10) labeled as
“Retract” to the retract port (upper) elbow (11) on
the base end of the Attachment Tilt cylinder.
Index the hose to remove any undo tension and
tighten the hose end completely.
b. Connect the right side hose (12) labeled as
“Extend” to the extend port (lower) elbow (13) on
the base end of the Attachment Tilt cylinder.
Index the hose to remove any undo tension and
tighten the hose end completely. MH0960
4
1
2
3
4
MH0940
~
5
6
7
8
9
MH1760
10
11
12
13