SkyTrak 8042 Service Manual - Manual (Page 234)

3.173 Model 8042, 10042, 10054 Legacy Rev. 03/04
Boom
3.10.4 Quick Attach Installation
1. Assemble the quick attach to the gooseneck. Line up
the quick attach (11) between the mounts on the
gooseneck. Assemble a washer (12), saved, on
each side of the quick attach. Reassemble the
shims (13), saved, between the quick attach and the
gooseneck. DO NOT put all the shims on one side.
The quick attach should be centered in the
gooseneck.
2. Coat the quick attach pivot pin (14) with an anti-seize
compound. Insert the quick attach pivot pin through
the gooseneck, washers, shims and quick attach.
Use a tapered punch to line up the hole in the pivot
pin with the hole in the quick attach.
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
3. Insert the capscrew (15), saved, through the quick
attach and pin. Secure the capscrew in place with a
new elastic locknut (16). Tighten securely.
4. Coat the rod end pivot pin (17), saved, with an anti-
seize compound. Swing the rod end (18) of the
Attachment Tilt cylinder up and line up the rod end
with the mounting holes in the quick attach (19).
Note: ALWAYS replace elastic locknuts with new elastic
locknuts to help ensure proper fastening.
5. Insert the rod end pivot pin (17) through the lined-up
holes. Use a tapered punch to line up the capscrew
hole in the pivot pin and the mounting hole in the
quick attach hub. Insert the capscrew (20), saved,
through the quick attach hub from the backside and
secure in place with a new elastic locknut (21).
Tighten securely.
MH1720
12
13
11
12
13
14
15
16
MH0940
~
17
18
19
20
21