SkyTrak 8042 Service Manual - Manual (Page 255)

Cab and Covers
4.16 Model 8042, 10042, 10054 Legacy Rev. 10/03
5. Connect the boom lift/lower control cable to the main
control valve assembly:
a. Install the cable in the bracket, and slide the jam
nut (1) over the end of the boom lift/lower control
cable (2). DO NOT tighten the jam nuts at this
time.
b. Connect the end of the cable to the shaft from
the control valve. Secure with an anchor pin and
spring pin (3).
c. Adjust the jam nuts until the distance (4) from the
outer jam to the end of the ferrule is the same as
recorded during removal. Tighten the jam nuts.
6. Repeat Step 5 to install the boom extend/retract
control cable (5).
Note: If any tie wraps were removed from the joystick
cables beneath the vehicle frame, bundle the cables and
secure with new tie wraps as required to prevent the
cables from contacting any sharp edges or moving parts.
7. Connect the battery negative (-) cable or cables to
the battery negative (-) terminal.
8. Start the engine.
9. Test the boom extend/retract and boom lift/lower
joystick (6) function:
a. Move the joystick handle rearward, activating the
boom lift function. The boom should RISE.
b. Move the joystick handle forward, activating the
boom lower function. The boom should LOWER.
c. Move the joystick handle to the right, activating
the boom extend function. The boom should
EXTEND.
d. Move the joystick handle to the left, activating the
boom retract function. The boom should
RETRACT.
10. Test the attachment tilt/frame sway joystick (7)
function:
a. Move the joystick handle rearward, activating the
attachment tilt function. The attachment should
TILT UP
b. Move the joystick handle forward, activating the
attachment tilt function. The attachment should
TILT DOWN.
c. Move the joystick handle to the right, activating
the frame sway function. The boom should frame
SWAY RIGHT.
d. Move the joystick handle to the left, activating the
frame sway function. The boom should frame
SWAY LEFT.
11. Install the console panel (9) and secure using four
button-head capscrews (8).
MA8480
1
2
3
4
5
OH2430
~
6
7
8
9
8