2GIG CT100 User Manual
Page 12
PG
12
12
Congratulations, you have successfully installed your unit. Please proceed to
the OPERATING Guide to initialize the CT100.
IMPORTANT:
If you have labeled and connected your wires
and followed the correct HVAC setup, and your system still does
not operate, contact technical support.
STATEMENT OF USE: This thermostat can be used with
4AA batteries, 24VAC (C wire), 24VAC adapter, heating
and cooling systems and also millivolt heating. It cannot
be used with line voltage systems. This thermostat
is digital and your desired heat or cool temperatures
can easily be set on the large touch screen with the
+/- buttons. A minimum 4 minute off time protects the
compressor from damage.
This thermostat runs on 4AA batteries. The CT100 can be
externally powered with a power source rated from 12V
to 24V, AC or DC, at 100ma or greater. If used, connect to the C and RH terminals (no polarity). The
24VAC “C” wire is the other side of the 24VAC heating transformer and can be found where the other
thermostat wires connect at the wall or at the furnace. Do not use the common or ground side of the
line voltage.
MENU
MODE
F
LINK
RADIO
TARGET TEMP
1
HEAT
AUTO