Apple Logic Pro X - Manual (Page 319)

Chapter 10 Create a song arrangement 319
Fades created using the Fade tool and the Region inspector are interactive. After you create a
fade using the Fade tool, for example, you can adjust the fade using the Region inspector Fade In
or Fade Out parameters.
Edit fades
You can change the length of a fade, the fade curve shape, the fade type, and the fade
playback speed.
You can also choose between four different fade types in the Region inspector.
Edit the length of a fade
Do one of the following:
m Drag over the start or end point of a fade with the Fade tool.
m Select a region, then edit the Fade In or Fade Out value in the Region inspector.
Adjust the fade curve shape
Do one of the following:
m Drag the fade curve with the Fade tool.
m Select a region, then edit the Curve value in the Region inspector.
In the example below, a positive curve is shown for both the fade-in and fade-out.
In this next example, a negative curve is shown for the fade-in, and a linear fade (no curve) is
shown for the fade-out.