Apple Logic Pro X - Manual (Page 589)

Chapter 19 Make global changes to a project 589
3 Set the following parameters, as required.
•
Create Tempo Change: Select one of the following options:
•
Globally: Uses the resulting tempo across the project.
•
At Selection Start and End: Uses the resulting tempo from the region selection start point up
to the selection end point, then changes back to the previously valid tempo.
•
At Selection Start Only: Uses the resulting tempo up to any previously existing tempo change
that follows the region selection end point, or to the project end if no tempo changes exist.
•
Nudge Regions to Beat: Select this checkbox to nudge the regions equally until the first
transient of the first region falls precisely on a whole beat of the ruler. The nudge direction is
either left or right, whichever results in the smaller movement range.
4 Click the Advanced Options disclosure triangle and set the following parameters, as required:
•
Adjust Value By: Define a ratio (multiplier and divisor) for the selected detection result. A ratio
of 2:1 multiplies the value by two, while a ratio of 1:2 divides the value by two.
•
Rounding: Choose one of the following rounding values: Integer, 1 Decimal, 2 Decimals, 3
Decimals, or Off. This value is used to modify the Resulting Tempo value.
5 Click the Prelisten button to preview playback using the Resulting Tempo value.
6 Click OK to perform the tempo adjustment (according to the above settings), or Cancel to cancel
the procedure.