Snorkel TB120 2001 - Manual (Page 18)

2. SAFETY DEVICES
5 2 - P/N 0191914
T
GUARDRAILS
The guardrails help protect you from falling off
the platform. Be sure the guardrails are
properly installed and that the gate is in place.
T
HORN
The operator HORN t is used primarily to get
the attention of people on the ground when you
are working aloft. The horn itself is located
below the tilt alarm sensor, it is the same horn
used to sound the tilt alarm. For the horn to
work the BATTERY switch must be ON and the
following switches, on the ground-control box,
must be set as indicated:
SELECTOR SWITCH..........PLATFORM
EMERGENCY STOP...............pulled out
MASTER KEY SWITCH....................ON
T
LANYARD ANCHOR POINTS
All personnel on the platform shall connect their
fall restraint lanyards to one of the lanyard
anchor points.
T
MOTION ALARM (option)
The motion alarm emits a loud beeping sound
at ground level anytime the DRIVE/STEER
controller is in FORWARD or REVERSE. This
alarm alerts people on the ground that the
TB120 is traveling along the ground.
T
PLATFORM WORK LIGHTS (option)
The platform work lights are located on top the
platform guard rail. Use the lights to improve
visibility when you are working aloft in dimly lit
areas. Do not use the platform work lights to
drive on public thoroughfares.
For more information about platform work lights
see the “OPTIONS” chapter.