Snorkel TB120 2001 - Manual (Page 37)

7. OPERATION
7 - 2 P/N 0191914
8. (OPTION - DUAL FUEL ) For machines set up
to run both gasoline and LP gas: Set the FUEL
switch to GASOLINE or L.P.-GAS depending on
which you want to use. If you select L.P.-GAS,
open the valve on top the LP gas tank.
‰ Starting (from the ground)
Do not attempt to start a TB120 until the actions
in the previous part of this section (“STARTING
FROM THE GROUND-CONTROL BOX”) have
been completed.
NOTE: You cannot raise or extend the main
boom unless the rear axles are extended and
locked. If you want to move the platform, from
the ground-control station, go to the "EXTEND
& LOCK REAR AXLES" section of this
chapter.
1. Insert the key (1) into the MASTER KEY
SWITCH (2).
2. Turn the key (1) to ON and pause there a few
seconds while an alarm sounds to alert others
that the TB120 is about to start.
NOTE: If you pause 30 seconds or more an
automatic protection feature will prevent the
TB120 from starting. If that happens, turn the
key to OFF and try again.
C A U TIO N
If the engine fails to start (at the next step) in 20
seconds, turn the key to OFF and wait 60
seconds before turning the key to START again.
3. Turn the key (3) to START and hold it there
until the engine starts (or for a maximum of 20
seconds) then release the key to ON.
The engine should now be running.