Snorkel TB120 2001 - Manual (Page 59)

10. DAILY INSPECTION & MAINTENANCE
10 - 1 P/N 0191914
10. DAILY INSPECTION
& MAINTENANCE
At the start of each work day (or 8 hour shift) a
TB120 qualified operator must perform the
DAILY INSPECTION AND MAINTENANCE listed
in the table below.
The purpose of the daily inspection and
maintenance is to keep the TB120 in proper
working condition and to detect signs of
malfunction at the earliest possible time.
D A N G ER
Do not operate a TB120 that is known
to be damaged or malfunctioning.
Defective parts or equipment
malfunctions jeopardize the safety of
the operator and other personnel, and
can cause damage to the machine.
DAILY INSPECTION AND MAINTENANCE TABLE
(Set the MASTER KEY SWITCH to OFF before you begin this inspection)
ITEM SERVICE REQUIRED
1. Engine fuel level Check fuel gauge (full)
2. Fuel tank cap Visually inspect (installation)
3. Engine oil Check oil level (between dipstick lines)
4. Fuel leaks Visually inspect (hoses, connections, etc.)
5. Engine coolant Check fluid level and radiator hoses
6. Wiring harnesses Visually inspect (installation, condition)
7. Battery terminals Visually inspect (no corrosion)
8. Battery fluid level Check fluid level (in contact with filler neck)
9. Hydraulic oil Check fluid level (between lines on gauge)
10. Hydraulic oil leaks Visually inspect (hoses, tubes)
11. Tires Visually inspect (condition)
12. Bolts and fasteners Visually inspect (looseness)
13. Structural damage & welds Visually inspect (weld cracks, dents)
14. Guardrails Visually check condition
15. Platform gravity gate Visually inspect (operation)
16. Self-closing gate Actuate and visually check condition
17. Lanyard anchor points Visually check condition
18. Axle/boom interlock Check operation
19. Emergency power motor/pump Check operation (causes correct motion)
20. Air filter Check condition (gauge)
21. Charging system Visually inspect (gauge)
22. Ground-control box switches and alarms Actuate and visually inspect for operation
23. Level sensor Actuate and listen for alarm
24. Platform-control box switches and alarms Actuate and visually inspect for operation
25. GFCI (Ground Fault Circuit Interrupt) Actuate and visually check for operation
26. Platform work lights Turn them on to see that they work
27. Flashing lights Turn them on to see that they work
28. Driving lights Turn them on to see that they work
29. Slide pads Visually inspect (boom wear marks)
30. Whiffles and wire ropes Visually inspect (even tension, condition)
31. Envelope management system Check operation
32. Placards and decals Visually inspect (installation, condition)