Snorkel TB120 2001 - Manual (Page 45)

7. OPERATION
7 - 10 P/N 0191914
C A U TIO N
If the engine fails to start (at the next step) in
20 seconds, turn the key to OFF and wait 60
seconds before turning the key to START
again.
7. Turn the key (7) to START and hold it there
until the engine starts (or for a maximum of 20
seconds) then release the key to ON.
The engine should now be running.
8. Set BOOMS/AXLES SWITCH (8) to AXLES.
NOTE: The engine rpm should automatically
increase when you switch to AXLES.
z At the AXLES controls:
C A U TIO N
Rear axle weight is about to be lifted by the
jack. Check to be sure the area under the jack
shoe plate will support that weight and that the
area is clear of objects that might be crushed.
1. Push and hold the jack control lever (1) to
RAISE until the rear wheels (2) are off the
ground and the jack (3) has stopped lifting the
chassis.
2. Remove the snapper pin (4) from the pin lock
(5) then remove the pin lock (5) from the upper
hole (6) in the chassis.
NOTE: You might have to cycle the axle
control lever (7) back and forth, to relieve
pressure on the pin lock (5), while you twist
and pull the pin lock (5) out of the chassis.
7 1
6
4
5
3
2
3. Push and hold the axle control lever (8) to
EXTEND until the axles (9) (10) stop extending.
NOTE: One axle will extend before the
other, they do not extend together.
1 0
9
8