Snorkel TB120 2001 - Manual (Page 48)

7. OPERATION
7 - 13 P/N 0191914
z At the AXLES controls:
C A U TIO N
Rear axle weight is about to be lifted by the
jack. Check to be sure the area under the jack
shoe plate will support that weight and that the
area is clear of objects that might be crushed.
1. Push and hold the jack control lever (1) to
RAISE until the rear wheels (2) are off the
ground and the jack (3) has stopped lifting the
chassis.
1
2
3
2. Remove the snapper pin (4) from the pin lock
(5) then remove the pin lock (5) from the lower
hole in the chassis (6).
NOTE: You might have to cycle the axle
control lever (7) back and forth a few times,
to relieve pressure on the pin lock (5), while
you pull the pin lock (5) out of the chassis.
7
4
5
6
3. Push and hold the axle control lever (8) to
RETRACT until the axles stop retracting.
NOTE: One axle might retract before the
other, they do not necessarily retract
together.
4. Completely insert the pin lock (9) into the
upper hole (10) in the chassis and install the
snapper pin (11) through the pin lock (9) and
the hole in the lip.
NOTE: You might have to cycle the axle
control lever (8) back and forth a few times,
to align holes inside the chassis, while you
push the pin lock (9) into the chassis.
8
1 0
11
9
5. Pull and hold the jack control lever (12) to
LOWER until the wheels are on the ground and
the jack stops retracting.
1 2