Snorkel TB120 2001 - Manual (Page 80)

12. OPTIONS
12 - 5 P/N 0191914
4. Attach the tow bar (7) to the towing lug (8) with
the tow pin (9) and snap pin (10).
5. Attach the tie rod weldment (11) to the tow bar
(7) and the right hand steering yoke (12).
C A U TIO N
Be sure the tow bar chain (shown on the left side
of the photo) goes over the tie-rod weldment
(11). If the chain goes under the tie-rod
weldment (11) left-hand turns will be restricted
and the tie-rod weldment might be damaged
when slack is removed from the chain.
6. Attach the two tow bar chains (13 typ.) to the
tie down lugs (14 typ.).
7. Attach the ring-end (15) of the tow bar to the
tow vehicle (16).
8. Use TURNTABLE SWING to rotate the
counterweight (17) back to the front of the
chassis.
9. Raise the platform approximately 3 feet (1 m)
to keep the platform from scraping the ground
when the TB120 starts up a grade.
10. Pull and twist the STEERING FLOAT VALVE
(18) to its “up” position.
NOTE: The STEERING FLOAT VALVE pin
should be as shown.
D A N G ER
A “runaway” TB120 can cause death or
serious injury. Disconnecting the disconnect-
plates will allow the TB120 drive wheels to
turn freely. Before proceeding, be certain the
tow bar is installed and connected to a
towing vehicle that can safely control both
itself and the TB120. Be certain the tow
vehicle brakes are set.