Snorkel TB120 2001 - Manual (Page 47)

7. OPERATION
7 - 12 P/N 0191914
1. Pull EMERGENCY STOP (1) out.
2. Set SELECTOR SWITCH (2) to GROUND.
3. Set ENGINE THROTTLE (3) to LO.
4. Set BOOMS/AXLES SWITCH (4) to
BOOMS.
5. Insert the key (5) into the MASTER KEY
SWITCH (6).
6. Turn the key (5) to ON and pause there a
few seconds while an alarm sounds to alert
others that the TB120 is about to start.
NOTE: If you pause 30 seconds or more an
automatic protection feature will prevent the
TB120 from starting. If that happens, turn
the key to OFF and try again.
C A U TIO N
If the engine fails to start (at the next step) in
20 seconds, turn the key to OFF and wait 60
seconds before turning the key to START
again.
7. Turn the key (7) to START and hold it there
until the engine starts (or for a maximum of 20
seconds) then release the key to ON.
The engine should now be running.
8. Set BOOMS/AXLES SWITCH (8) to AXLES.
NOTE: The engine rpm should automatically
increase when you switch to AXLES.