IKA C 7000 Grundausstattung Set 2 - Manual (Page 60)

 (YDOXDWLRQ RI &DORULILF 9DOXH 7HVWV
IKA  -WERKE C 7000 Ver. 07 09.07
3DJH 
K\JU PRLVWXUH DQ Percentage of water from hygroscopic moisture
Calculation modes: FRDO  W FRDO  W
VXOSKXU DQ Percentage of sulphur
Calculation mode: FRDO  W
 7HVW VLPXODWLRQ
In some cases, it is helpful to run through calorific-value tests or to calculate possi-
ble test results without actually carrying out a combustion test. Under PHQX  
PDQXDO  PHDVXUH you can enter the temperature increase of a test manually.
This is especially useful if a calibration has been accidentally carried out instead of a
calorific-value determination or vice versa. By using the measured temperature in-
crease, a misinterpreted measurement can be corrected by simulation.
To enter a temperature increase for a particular test, proceed as follows:
c
In PHQX  , enter the pre-test parameters ( SUHSDU ) for the test.
d
From PHQX  , go to the sub-menu PDQXDO , and from there to sub-menu PHDVXUH .
You will be asked for the VDPSOH FRGHV .
e
Use the alpha-numeric keys to enter the code for the test that is to be simulated,
and then press the
↵
button. The LCD-display shows the enquiry LQFUHDVH LQ WHP
SHUDWXUH .
f
Use the number keys to enter the required temperature increase, and then press the
↵
button. The enquiry ERPEQR appears in the LCD-display.
g
Use the number keys to enter the number of the decomposition vessel, and then
press the
↵
button. In the second line of the LCD-display, the enquiry PHP VDYH
appears briefly. After it has disappeared, pressing the PHP button stores the data
entered. The green LED near the 9 EXWWRQ blinks to indicate the end of the simu-
lated test. Acknowledge this with the 9 EXWWRQ , and exit this program.