IKA C 7000 Grundausstattung Set 2 - Manual (Page 65)

IKA  -WERKE C 7000 Ver. 07 09.07
3DJH 
0HVVDJH &DXVH 5HPHG\
WHVW QRW \HW SULQWHG You have attempted to change
the parameters of a test that has
not yet been printed out.
Print test at least once, and then
edit.
ORVV RI SRZHU VXSSO\ An interruption in the power
supply has been detected.
Possibly too many consumers are
connected to a single socket, which
has caused a brief voltage drop.
Connect C 7000 to a separate
socket.
37 SDUDPHWHUV PLVVLQJ A test can only be carried out
after pre-test parameters have
been entered.
Enter pre-test parameters.
Check that you have not entered the
wrong sample code.
9 WLPHG RXW Data could not be sent through
the V24 interface to the PC.
Check interface parameters and
connection cable. Make sure that
external PC is ready.
VFDOH WLPHG RXW Data could not be sent to the
balance, or the balance does not
respond.
Balance reading has not yet
stabilised. Check interface
parameters and connection cable.
PHPRU\ KDV EHHQ
UHLQLWLDOL]HG
After the program was started, a
memory error was detected, and
the memory reinitialized. Test
data have been erased.
If this problem occurs frequently, the
battery on the MC board must be
changed (by the Technical Service
Department or an instructed
specialist).
SUREOHP ZLWK FORFN
VWRUDJH
After the program was started, a
memory error was detected in
the clock unit.
Check date and time, and reset if
necessary. If this problem occurs
frequently, the clock unit must be
changed (by the Technical Service
Department or an instructed
specialist).
FORFN EDWWHU\ GHDG The clock unit battery is empty. The clock unit must be changed (by
the Technical Service Department or
an instructed specialist).