JLG 660SJ Service Manual - Manual (Page 145)

SECTION 3 - CHASSIS & TURNTABLE
3121298 – JLG Lift – 3-101
Fuel System Checks 2 Check for Rich or Lean symptom that causes the condition. Drive the vehicle at the speed of the complaint. Monitoring the oxygen sensors will
help identify the problem.
2 Check the fuel pressure while the condition exists. Refer to LPG Fuel System Diagnosis.
2 Verify proper fuel control solenoid operation.
2 Verify that the LPG manual shut-off valve is fully open.
2 Check the in-line fuel filter for restrictions.
Ignition System Checks 2 Check for the proper ignition output voltage using the spark tester J26792 or the equivalent.
2 Verify that the spark plugs are correct for use with LPG (R42LTS)
2 Check the spark plugs. Remove the plugs and inspect them for the following conditions:
- Wet plugs
- Cracks
- Wear
- Improper gap
- Burned electrodes
- Heavy deposits
- Check the Crankshaft Position (CKP) sensor.
Additional Check 2 Check the ECM grounds for being clean, tight, and in their proper locations.
2 Check the generator output voltage.
2 Check the vacuum hoses for kinks or leaks.
2 Check Transmission
Table 3-12. Symptom Diagnosis
Checks Action