Cover disassembly, Cover assembly, Cover disassembly -8 cover assembly -8 – JLG 660SJ Service Manual User Manual
Page 52: Torque hub cover -8
SECTION 3 - CHASSIS & TURNTABLE
3-8
– JLG Lift –
3121298
Cover Disassembly
1.
Remove O-Ring (17) from groove in Cover (6A).
2.
Remove Thrust Washer (2) from Cover (6A) pockets.
3.
Unscrew two Hex Head Bolts (6C) and remove Disen-
gage Cap (6B) from Cover (6A).
4.
Pull Disengage Rod (6D) out from Cover (6A).
5.
Use appropriate tool to remove O-ring (6E) from internal
groove in Cover (6A).
6.
Remove two O-Ring Pipe Plugs (6F) from Cover (6A).
Cover Assembly
1.
Grease O-Ring (6E) and insert in internal groove in Cover
(6A).
2.
Assemble Disengage Cap (6B) on Cover (6A) using two
Hex Head Bolts (6C). Torque bolts to 70-80 in-lbs.
3.
Insert Disengage Rod (6D) in hole in Cover (6A) until it
touches inside of Disengage Cap (6B).
NOTE:
Disengage Rod can be inserted either end first.
4.
Grease face of Thrust Washer (2) and place in Cover (6A).
Make sure tangs on washer seat into pockets in cover.
5.
Install O-Ring Pipe Plugs (6F) in Cover (6A). Plugs should
be hand tight.
Figure 3-9. Torque Hub Cover
2
17
6A
6E
6D
6B
6C
6G
6F