Machine configuration programming information -33 – JLG 660SJ Service Manual User Manual
Page 279
SECTION 6 - JLG CONTROL SYSTEM
3121298
– JLG Lift –
6-33
Table 6-5. Machine Configuration Programming Information
Configuration Digit
Number
Description
Default
Number
NOTE:
Machine configuration must be completed before any personality settings can be changed. Changing personality set-
tings first and then changing the model number of the machine configuration will cause personality settings to return to
default
MODEL NUMBER:
1
0
4
No Model
600S
0
1
MARKET:
2
0
1
2
3
4
5
ANSI USA
ANSI EXPORT
CSA
CE
AUSTRALIA
JAPAN
0
ENGINE:
3
8
9
12
13
DEUTZ F4 TIER1: Deutz BF4M1011 Diesel (Tier 1)
DEUTZ F4 TIER2: Deutz BF4M2011 Diesel (Tier 2)
DEUTZ ECM: Engine Control Module
CAT Engine
14
FLYWHEEL TEETH:
4
0
1
133 TEETH: 133 flywheel teeth.
110 TEETH: 110 flywheel teeth.
1
GLOW PLUG:
5
0
1
2
NO GLOW PLUGS: No glow plugs installed.
AIR INTAKE: Glow plugs installed in the air intake on the manifold.
IN-CYLINDER: Glow plugs installed in each cylinder.
2
STARTER LOCKOUT:
6
0
1
DISABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start can be attempted at any time during pre-glow.
ENABLED: Automatic pre-glow time determined by ambient air tempera-
ture; engine start is NOT permitted until pre-glow is finished.
0
ENGINE SHUT-
DOWN:
7
0
1
DISABLED: No engine shutdown.
ENABLED: Shutdown engine when coolant temperature is greater than
110°C or oil pressure is less than 8 PSI.
1