JLG 660SJ Service Manual - Manual (Page 280)

SECTION 6 - JLG CONTROL SYSTEM
6-34 – JLG Lift – 3121298
TILT:
8 1



2


3


4



5
5 DEGREES: Reduces the maximum speed of all boom functions to creep
when tilted more than 5 degrees and above elevation; also reduces drive
speed to creep.

4 DEGREES: Reduces the maximum speed of all boom functions to creep
when tilted more than 4 degrees and above elevation; also reduces drive
speed to creep.

3 DEGREES: Reduces the maximum speed of all boom functions to creep
when tilted more than 3 degrees and above elevation; also reduces drive
speed to creep.

4 DEGREES + CUT: Reduces the maximum speed of all boom functions to
creep when tilted more than 4 degrees and above elevation; also disallows
tower lift up, tower telescope out, drive, main telescope out and main lift up.

3 DEGREES + CUT: Reduces the maximum speed of all boom functions to
creep when tilted more than 3 degrees and above elevation; also disallows
tower lift up, tower telescope out, drive, main telescope out and main lift up.
1
Note: Any of the selections above will light the tilt lamp when a tilted condition occurs and will sound the platform alarm when
the machine is also above elevation.
JIB:
9 0
1 NO: No Jib installed.
YES: Jib installed which has up and down movements only. 0
4 WHEEL STEER:
10 0
1 NO: No four-wheel steer installed.
YES: Four wheel steer installed 0
STOUCH/SKY-
GUARD
:
11
0
1
2
3 NO: No soft touch or SkyGuard system installed.
SOFT TOUCH: Soft touch only installed.
SKYGUARD: SkyGuard only installed.
BOTH (CUTOUT) - Soft touch and SkyGuard installed. 0
GEN SET/WELDER:
12 0
1 NO: No generator installed.
BELT DRIVE: Belt driven setup 0
GEN SET CUTOUT:
13* 0
1 MOTION ENABLED: Motion enabled when generator is ON.
MOTION CUTOUT: Motion cutout in platform mode only. 0
* Only visible if Gen Set / Welder Menu selection is not 0.
Table 6-5. Machine Configuration Programming Information
Configuration Digit Number Description
Default
Number