JLG 600SC_660SJC Operator Manual - Manual (Page 13)

SECTION 1 - SAFETY PRECAUTIONS
3121606 – JLG Lift – 1-3
1.3 OPERATION
General
• Do not use the machine for any purpose other than position-
ing personnel, their tools, and equipment.
• Never operate a machine that is not working properly. If a mal-
functions occurs, shut down the machine.
• Never slam a control switch or lever through neutral to an
opposite direction. Always return switch to neutral and stop
before moving the switch to the next function. Operate con-
trols with slow and even pressure.
• Hydraulic cylinders should never be left fully extended or fully
retracted before shutdown or for long periods of time.
• Do not allow personnel to tamper with or operate the
machine from the ground with personnel in the platform,
except in an emergency.
• Do not carry materials directly on platform railing. Contact JLG
for approved material handling accessories.
• When two or more persons are in the platform, the operator
shall be responsible for all machine operations.
• Always ensure that power tools are properly stowed and never
left hanging by their cord from the platform work area.
• Supplies or tools which extend outside the platform are pro-
hibited unless approved by JLG.
• When driving, always position boom over rear axle in line with
the direction of travel. Remember, if boom is over the front
axle, steer and drive functions will be reversed.
• Do not assist a stuck or disabled machine by pushing, pulling,
or by using boom functions. Only pull the unit from the tie-
down lugs on the chassis.
• Do not place boom or platform against any structure to steady
the platform or to support the structure.
• Stow boom and shut off all power before leaving machine.
Trip and Fall Hazards
During operation, occupants in the platform must wear a full
body harness with a lanyard attached to an authorized lanyard
anchorage point. Attach only one (1) lanyard per lanyard anchor-
age point.