JLG 600SC_660SJC Operator Manual - Manual (Page 47)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121606 – JLG Lift – 3-13
NOTE: When boom is positioned above horizontal and any of the fol-
lowing switches, DRIVE SPEED/TORQUE SELECT or FUNCTION
SPEED, are positioned to HIGH, high function speeds are auto-
matically cut out and the machine continues to operate at a
lower speed.
NOTE: The drive/steer control joystick can only command counter-
rotate by being moved in the joystick's left - to - right axis, after
first achieving the joystick neutral position.
DO NOT OPERATE MACHINE IF DRIVE SPEED /TORQUE SELECT OR FUNCTION SPEED
SWITCHES OPERATE WHEN BOOM IS ABOVE HORIZONTAL.
9. Telescope
Provides extension and retraction of the main
boom.
10. Lights (If Equipped)
This switch operates accessory light packages
if the machine is so equipped.
11. Jib (If Equipped)
Push forward to lift up, pull back to lift down.
Variable lift speed is using the Function Speed
Control.
12. Platform Rotate
Provides rotation of the platform when posi-
tioned to the right or left.
13. Soft Touch Override Switch (If equipped)
This switch enables the functions that
were cut out by the Soft Touch system to
operate again at creep speed, allowing the operator to move
the platform away from the obstacle that caused the shut-
down situation.
14. Soft Touch Indicator (If Equipped)
Indicates the Soft Touch bumper is against
an object. All controls are cut out until the
override button is pushed, at which time controls are active
in the Creep Mode.